Jumpking 12ft User Manual

YJ USA Corp., 3970 Lindbergh Drive Adison, TX 75001WARNINGwww.jumppod.com877-928-8777

thesharplyspot.



151. Make sure you understand the information inthe box at the top of this page before youbegin assembling the trampoline.Lay three Top Tubes (1), (2)

16FrameHolesV-rings810101010Springs (10)22Hook the V-ringV-ring81010FrameBlack webbing with yellow lineNo yellow line3. Lay the Bed (8) on the

1744. Lay the Frame Pad (9) on the frame. Do not use the trampoline without the Frame Pad (9), which is designed to reduce the likelihood of injury to

6. Using the included plastic tie, attach the SafetyPlacard (11) to the frame near the point wherejumpers will climb onto and off the trampoline.The t

10. Attach the other three Pole(16,17) in the same way. See inset drawing.101911. Lay out Top G3 Pole (18), joint each section Co

13. Note: During steps 14 and 15, you will “sew”the lower edge of the Netting(20) to the V-rings on the bed using the Cords(25). Locate

3

22It is possible for the trampoline/enclosure be blown about by high wind. If you anticipate high winds, the trampoline/enclosure should be moved to

1 4 Top Tube(With T-connector, A marking) 2 4 Top Tube(With Socket, B marking) 3 4 Top Tube(With T-connector, C marking) 4 8 T-Connector 5 8 Leg Ext

3. Place the trampoline and trampoline enclosure on a level surface before use.4. Must place the trampoline on lawn, bark wood chip, sa

525. Do not attach anything to the barrier that is not a manufacturer approved accessory or part of the enclosure system. 26. Wear clothi

6Note: The